Origami - Rose

cutie

Introduce:
There are already quite a few directions as to folding a rose but this one in particular is different. While other origami roses use the conventional origami paper, this one requires creased paper (a very stretchable and flexible kind).

cutie

1. The dimensions should be 60cm in length and 8cm in width. Fold the piece horizontally in half.

cutie

2. Fold the right top side as shown above.

cutie

3. Align the top and fold it into half again.

cutie

4. The right tip folds over to the left, whereby aligning it to the left side.

cutie

5. Following the diagonal line, fold it backwards. It is important to press on the fold lightly at this point.

cutie

6. Hold onto the tip that is circled and roll it around toward the same direction. Note: the parallel lines indicate the twisting/rolling around the inner rose part.

cutie

7, 8. Be careful not to press too hardly on the circled part or else the rose will not have the opulent effect at the end. After turning the piece around, you will have an extra 2cm at the end. Fold that piece over to the back as indicated above.

cutie

9, 10. Repeat step 7 until you don\'t have any more paper left to twist it around again. Fold the residual piece and conform it to the rose.

cutie

11. Use a wire and flower tape to fasten the rose. Lastly, secure the stem to the flower. The rose is ready!

cutie

Final, the completed roses

cutie

Actually, the rose can be also made by Chinese knots.
It is the combination of button knot and double coins knot.

babybaby

漂亮

宝贝城城主

真漂亮啊！怎么叫手巧啊，看看人家做的就知道啦！

luye3517

I can make it in another way, but i can\'t introduce the infomation......

luye3517

By the way,
can\'t you introtuce the infomation of Chinese knots?